English | Chinese |
A blaster must make an estimate of the maximum possible distance flyrock could travel from a shot | 爆破人员务必要估计出飞石自爆炸点可能行走的最大距离 |
absolute maximum value | 绝对最大值 |
allowable maximum limiting stripping ratio | 最大允许极限剥采比 |
An adequate priming ensures that the explosive will reach its maximum velocity as quickly as possible under the condition of use | 充足的起爆药保证炸药在使用时可尽快达到最大速度 |
angle of maximum subsidence | 最大下沉角在非充分采动条件下,移动盆地倾向主断面上,采空区中点和地表最大下沉点在基岩面上投影点的连线与水平线在下山方向的夹角 |
Between these two extremes, a maximum throw distance may be expected | 在这两个极端之间、我们可以找到最大抛掷距离 |
Blasters should always ensure a maximum velocity of the explosives to be used by following the priming procedures recommended by the explosives manufacturers | 爆破人员应该始终遵循炸药厂家所推荐的起爆程序、以确保所用炸药的最大爆速 |
dimensionless maximum shear stress | 最大无量纲剪切应力 |
dynamic maximum flexural strength | 最大动态挠曲强度 |
establishing maximum projection distance | 建立最大保护距离 |
factors affecting maximum protection range | 影响最大保护距离的因素 |
In addition to factors that are related to geology and distance are those factors that are related directly to the design of blasting operations. The most important of these is the maximum charge weight per delay: that is, the maximum quantity of explosive that detonates at one time sometimes specified as being that which detonates within any eight millisecond period of time | 除了与地质和距离有关的因素外、还有一些因素与爆破作业设计直接相关。其中最重要的是每次延迟的最大装药量、即每次要爆炸的炸药最大量有时标明为每8毫秒间隔爆炸的炸药量 |
launch angle for a maximum range | 最大范围的发射角 |
maximum average value | 最大值平均值某项试验指标中,大于算术平均值的诸测定值的平均值 |
maximum blasting capacity | 最大爆炸能力 |
maximum breaking capacity | 最大断开限度 |
maximum burden | 最大抵抗线如果所有炮孔都按设计布置〈没有炮孔偏差〉,为达到良好块度的最大抵抗线,单位为 m。由于“良好块度”是一个很难量化的术语,建议不使用“最大抵抗线距离”这一术语 |
maximum charge | 最大装药量用煤矿许用炸药作巷道试验时,不会引起瓦斯和煤尘着火爆炸的最大药量叫不发火药量。但是,在实际使用时要计人一定的安全系数,此时的炸药量叫最大装药量或安全极限药量 |
maximum charge per delay interval | 间隔最大装药量在一次爆破中单位延时间隔的最大药量〈kg〉。爆炸的最小装药的延时间隔时间为8ms |
maximum clearance | 最大射孔间隙在射孔方向上射孔器外表面与靶间的最大距离 |
maximum coupling effect | 最大耦合效应 |
maximum distance of throw | 最大抛掷距离 |
maximum dry bulk weight | 最大干容重在一定压实功能作用下,黏性土达到最密实状态时的干容重,常以 kN/m³表示 |
maximum dry density | 最大干密度在一定压实功能作用下,黏性土达到最密实状态时的干密度,以g/cm³或 t/ m³表示 |
maximum explosive charge per delay | 每次延迟最大装药量 |
maximum explosive point | 最高爆炸点 |
maximum recommended firing current | 最大建议点火电流安全有效点燃电雷管所需的最大建议电流,单位为A〈安培〉。电流过大会损坏雷管并造成瞎炮 |
maximum flying height of fly rock | 飞石飞行的最大高度又称个别飞散物飞行的最大高度。是指个别飞石作抛掷运动 |
maximum flyrock distance | 飞石飞行的最大距离 |
maximum fracture | 最大裂缝穿孔后在套管上造成的最长和最宽的裂缝 |
maximum fragment size | 最大破碎粒度碎片尺寸分布中最大的方形碎片尺寸,单位为m。由于很难有明确的定义,因此建议采用如下方式来确定最大碎片尺寸:将最大的碎片放在水平面上对其表面进行投影,找到能够刚好使该投影通过的最小网目,该网目即定义为最大碎片尺寸K100 |
maximum fragment size | K100碎片最大尺寸 |
maximum horizontal throw | 最大水平抛掷距离 |
maximum horizontal throw of a projectile | 抛物体的最大水平抛掷距离 |
maximum instantaneous charge | 最大瞬发药量 |
maximum instantaneous charge MIC | 最大瞬时药量参见 maximum charge per delay interval |
maximum linear strain theory | 最大线应变理论认为岩土的破坏是由于最大伸长线应变达极限值而引起的及由此而建立的张性破坏强度准则 |
maximum lump size | 最大块度 |
maximum mine inflow | 矿井最大涌水量矿井开采期间,正常情况下矿井涌水量的高峰值 |
maximum molecular water capacity | 最大分子水容度由分子力维持的水量达最大值时,土中水分的质量与固体颗粒质量之比,以百分数表示 |
maximum non-firing current | 最大不发火电流电雷管在规定的通电时间内达到规定的不发火概率所能施加的最大电流 |
maximum normal velocity | 最大法向速度 |
maximum OD of cut flare pipe | 管材最大张开直径被切割管材向外扩张后的最大外径 |
maximum OD of perforator | 射孔器最大直径射孔器下井作用时的最大外径。有枪身射孔器即为枪身和接头的最大外径,无枪身射孔器则指联弹后的最大外径 |
maximum peak particle velocity-PPV | 质点最大速度爆炸产生的颗粒在三个直角方向上测得的速度峰值,单位为 mm/s |
maximum permissible dustiness | 最大允许起尘量 |
maximum permissible size | 最大允许粒度 |
maximum permissible size | 最大允许尺寸 |
maximum permitted charge | 最大允许装药量 |
maximum pore ratio | 最大孔隙比砂土于最疏松状态时的孔隙比 |
maximum principal stress | 最大主应力三向应力状态中,数值最大的为主应力 |
maximum projection range | 最大工程量范围 |
maximum radial strain of the longitudinal wave | 纵向波最大散射力置于岩石炮孔中完全充填炮孔区域的炸药爆炸发射出的纵向波所诱发的最大散射力。相邻炮孔的最大散射力可以由公式计算 |
maximum raise and maximum decay rates | 最大上升率和最大衰减率 |
maximum resultant ground vibration velocity | 最大诱发地面振动速度爆破诱发的地面最大振动速度,单位为 mm/s |
maximum safety current | 最大安全电流 |
maximum scattering distance of fly rock | 飞石最大飞散距离又称个别飞散物最大飞散距离。是指个别飞石作抛掷运动时,抛掷的最远距离 |
maximum shear stress | 最大剪应力三轴应力状态下,数值最大的剪应力,其值等于最大与最小主应力差的二分之一 |
maximum shear stress theory | 最大剪应力理论认为岩土产生剪切破坏是由于最大剪应力达极限值而引起的和由此建立的强度准则 |
maximum single-stage charge quantity | 最大单段装药量 |
maximum strain | 最大应力 |
maximum surface temperature | 最高表面温度在最不利的运行条件下,设备暴露于环境大气的外部表面所达到的最高温度 |
maximum S-wave component of particle velocity | 最大 S 波粒子速度地面震动中S波组分的最大速度 |
maximum tensile to shear stress ratio | 最大张应力与剪应力之比 |
maximum throw distance | 最大扬程距离 |
maximum velocity loading | 最大速度加载 |
maximum vertical component of particle velocity | 垂直粒子组分的最大速度垂直粒子组分的运动速度最大值,单位为 mm/s |
maximum water yield of mine | 矿井最大涌水量矿井开采期间,正常情况下矿井涌水量的高峰值 |
mt maximum torque | 最大转矩 |
point of maximum strain | 最大应变点 |
point of maximum subsidence | 最大塌陷点 |
The general trajectory formula needs to be applied here for the prediction of the maximum horizontal throw of a projectile to a point at the same elevation | 这里需要应用预测抛物体在同一高程时的最大抛掷距离的弹道公式 |
The maximum flyrock distance decreases with an increase in stemming length。 | 飞石飞行的最大距离随着炮泥堵塞长度的增加而减小 |
Usually cast blast design involves maximizing the castover. However, in other situations less than maximum cast may be desired. This can occur far example if the after blast profile from maximum casting would lower the dragline elevation to the point where the machine has inadequate stacking height | 通常在进行爆破方案设计时希望使抛掷量最大化。但是、在一些情况下并不需要达到最大抛掷量。例如当达到最大抛掷量会使得吊铲达不到最佳的工作高度时、反而造成爆后利润的降低 |